Jobs stopped for some reason

Help and Support
1

Hi, all.

I’m really new to rclone, but had it working fine for about a week on a VPS running Ubuntu server. Then, today, it stopped working. Whenever I am trying to do anything with rclone the job is stopped after a few seconds. It doesn’t matter if I am copying files or just editing something in rclone config. I got my server host to reset the VPS, since I figured if I was to start from scratch it would probably be fixed, but alas. I am new to Linux, but I hope there are someone here who can give me some pointers in how I can locate the culprit and get it working again.

The VPS has 4,3GB of RAM, same amount of SWAP, and 2vCores @ 3.70 GHz.

2

So, I thought I should try another server host to rule out something about the setup of the one I was with, and went with a Scaleway VPS with 8GB RAM and SSD. And guess what: the same thing happens here. I am at my wit’s end.

3

Set up a Debug log…

4

Did you find out what was happening? What did the log say?

5

From what I can gather from the log file, it gets a googleapi: Error 403 but then resumes until it suddenly stops.

    2017/03/28 14:21:34 DEBUG : pacer: low level retry 1/10 (error googleapi: Error 403: Rate Limit Exceeded, rateLimitExceeded)
2017/03/28 14:21:34 DEBUG : pacer: Resetting sleep to minimum 10ms on success
2017/03/28 14:21:34 DEBUG : pacer: Rate limited, sleeping for 1.184312746s (1 consecutive low level retries)

The end of the log is:

2017/03/28 14:22:53 INFO  : Cabernet/._CabernetJF-Regular.bmap: Copied (new)
2017/03/28 14:22:55 DEBUG : of6uu70fc09bpahi7ktcnbahcg: Sending chunk 58720256 length 8388608